6. Metal finish the repair area using typical metal finishing techniques.
7. Prime the repair area using a Ford approved paint system.
8. Sealing work: All areas must be sealed to production level. Material : Seam Sealer / TA-2-B
9. Restore corrosion protection. Refer to: Corrosion Prevention (501-25 Body Repairs - General Information, General Procedures).
10. Install the following items:
1. Refer to: Quarter Panel - Coupe (501-30 Rear End Sheet Metal Repairs, Removal and Installation). Refer to: Quarter Panel - Convertible (501-30 Rear End Sheet Metal Repairs, Removal and Installation).
2. Refer to: B-Pillar and Reinforcement - Coupe (501-29 Side Panel Sheet Metal Repairs, Removal and Installation). Refer to: B-Pillar and Reinforcement - Convertible (501-29 Side Panel Sheet Metal Repairs, Removal and Installation).
3. Refer to: A-Pillar Trim Panel - Coupe (501-05 Interior Trim and Ornamentation, Removal and Installation). Refer to: A-Pillar Trim Panel - Convertible (501-05 Interior Trim and Ornamentation, Removal and Installation).
4. Refer to: A-Pillar Outer Panel Section and Reinforcement (501-29 Side Panel Sheet Metal Repairs, Removal and Installation).
Copyright © 2016 Ford Motor Company
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.