Back Panel and Reinforcement
Special Tool(s) / General Equipment
Resistance Spotwelding Equipment
Hot Air Gun
8 mm Drill Bit
MIG/MAG Welding Equipment
Spot Weld Drill Bit
Locking Pliers
Materials
Name | Specification |
|---|---|
Metal Bonding Adhesive TA-1, 3M™ 08115, Fusor® 108B | - |
Seam Sealer TA-2-B | - |
Removal
1. If required , dimensionally restore the vehicle to pre-accident condition. Refer to: Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation).
2. Remove the following items:
1. Refer to: Rear Bumper (501-19 Bumpers, Removal and Installation).
2. Refer to: Rear Lamp Assembly (417-01 Exterior Lighting, Removal and Installation).
3. Reposition the carpeting and the wiring harness away from the working area.
4. Refer to: Joining Techniques (501-25 Body Repairs - General Information, General Procedures).
5. Drill out the spot welds from the back panel. Use the General Equipment: Spot Weld Drill Bit
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.