MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Climate Control System

Climate Control System - Vehicles With: Dual Automatic Temperature Control (DATC)

412-00 Climate Control System - General Information

2016 MustangReference 3,509 / 6,619HTML edition
← Chapter contentsProcedure contents

Service Bulletins (TSBs) address this concern, INSTALL a new FCIM. Refer to the appropriate section in Group 415 for the procedure.

No

The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.

B1A63:11, B1A63:15, B1A64:11, B1A64:15

Refer to Wiring Diagrams Cell 55 for schematic and connector information.

Normal Operation and Fault Conditions

Sunload Sensor, REFER to: Climate Control System - Vehicles With: Dual Automatic Temperature Control (DATC) - System Operation and Component Description (412-00 Climate Control System - General Information, Description and Operation).

DTC Fault Trigger Conditions

DTC

Description

Fault Trigger Conditions

B1A63:11

Right Solar Sensor: Circuit Short To Ground

This DTC sets when the control module senses lower than expected voltage on the RH sensor feedback circuit, indicating a short to ground.

B1A63:15 Right Solar Sensor: Circuit

Short To Battery or Open

This DTC sets when the control module senses higher than expected voltage on the RH sensor feedback circuit, indicating a short to voltage or an open circuit or sensor.

B1A64:11

Left Solar Sensor: Circuit Short To Ground

This DTC sets when the control module senses lower than expected voltage on the LH sensor feedback circuit, indicating a short to ground.

B1A64:15 Left Solar Sensor: Circuit

Short To Battery or Open

This DTC sets when the control module senses higher than expected voltage on the LH sensor feedback circuit, indicating a short to voltage or an open circuit or sensor.

Possible Sources

Wiring, terminals or connectors Sunload sensor FCIM

Inspect loose or corroded FCIM and sunload sensor connections.

PINPOINT TEST O : B1A63:11, B1A63:15, B1A64:11, B1A64:15

NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.

O1 CHECK THE SUNLOAD SENSOR CIRCUITS FOR A SHORT TO VOLTAGE

Ignition OFF. Disconnect Sunload sensor C286. Disconnect FCIM C2402B. Disconnect BCM C2280B. Ignition ON. Measure:

Source reference 3509

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.