The Front USB Port (USB1) Is Inoperative Or Does Not Operate Correctly
Refer to Wiring Diagrams Cell 132 for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Information and Entertainment System - System Operation and Component Description (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Description and Operation). See SYNC® AppLink™, USB Audio Mode, and USB Port.
The MIT 105-00120 is powered by the USB port
DTC Fault Trigger Conditions
Original table alignment retained · Scroll horizontally if needed
Possible Sources
Customer's device Front USB port/cable USB port/cable connection APIM
PINPOINT TEST U : THE FRONT USB (UNIVERSAL SERIAL BUS) PORT (USB1) IS INOPERATIVE OR
DOES NOT OPERATE CORRECTLY
U1 CHECK THE FRONT USB (UNIVERSAL SERIAL BUS) PORT FOR POWER OUTPUT
Ignition ON. Connect: MIT 105-00120 to the front USB port.
Does the MIT 105-00120 power on from the front USB port?
Yes | GO to U2 |
|---|---|
No | GO to U3 |
U2 RESET THE APIM (SYNC MODULE) AND RECHECK THE SYNC® SYSTEM OPERATION
Remove any devices connected to the USB ports and audio input jack. Carry out an APIM power reset by disconnecting the battery for 1 minute, then reconnecting it. Ignition ON. Wait at least 2 minutes for the APIM to re-initialize. Connect: MIT 105-00120 to the front USB port.
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.