The FDIM Is Inoperative Or Does Not Operate Correctly

Yes	CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new ACM. REFER to: Audio Front Control Module (ACM) (415-00B Information and Entertainment System - General Information - Vehicles With: Touchscreen Display, Removal and Installation).
No	The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.

Yes

CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new ACM. REFER to: Audio Front Control Module (ACM) (415-00B Information and Entertainment System - General Information - Vehicles With: Touchscreen Display, Removal and Installation).

The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.

Normal Operation and Fault Conditions

REFER to: Information and Entertainment System - System Operation and Component Description (415-00B Information and Entertainment System - General Information - Vehicles With: Touchscreen Display, Description and Operation). See FDIM.

DTC Fault Trigger Conditions

DTC Description Fault Trigger Conditions DTC Type B108E:01 Display: General Electrical Set by the APIM when an internal connection Continuous Failure concern or internal LCD panel concern is detected in the FDIM. B108E:12 Display: Circuit Short To Battery Despite the DTC description, this DTC is set by Continuous the APIM when an open is detected on the LVDS (Low Voltage Differential Signaling) cable. B108E:63 Display: Circuit / Component Set by the APIM when the FDIM detects a touch Continuous Protection Time-Out input for more than 2 minutes during normal operation. U0162:00 Lost Communication With Set by the APIM when communication is missing Continuous and Navigation Display Module: No from the FDIM for more than 1 second with the on-demand Sub Type Information ignition in RUN.

Original table alignment retained · Scroll horizontally if needed

Possible Sources

LVDS (Low Voltage Differential Signaling) cable FDIM Object pressed against the FDIM touchscreen APIM

PINPOINT TEST AE : THE FDIM (FRONT DISPLAY INTERFACE MODULE) IS INOPERATIVE OR DOES

NOT OPERATE CORRECTLY

AE1 VERIFY THE FDIM (FRONT DISPLAY INTERFACE MODULE) RESPONSE TO TOUCH COMMANDS

Ignition ON. Perform various FDIM touch commands and observe the FDIM operation.

Does the FDIM respond correctly to each touch command?

Source reference 4484

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.