2. If equipment meeting the specifications above is not available, the transmission fluid cooler(s) should be replaced and the lines cleaned by hand.
3. Check and top off fluid level of the transmission cooling system heated flusher with transmission fluid.
Use the General Equipment: Transmission Cooling System Heated Flusher
Material
: Motorcraft® MERCON® LV Automatic Transmission Fluid (U.S.) / XT-10-QLVC (U.S.) (MERCON® LV) (WSS-M2C938-A)
4. Turn on the heater and allow the fluid in the cooler line flusher 15-30 minutes to heat up to 60°C (140°F) before using.
5. Install the line adapters onto the transmission fluid cooler tubes.
6. Attach the Transmission Cooling System Heated Flusher red line to the transmission fluid cooler inlet tube. Refer to: Transmission Cooling - Component Location .
7. Attach the Transmission Cooling System Heated Flusher blue line to the transmission fluid cooler outlet tube.
8. Follow the Transmission Cooling System Heated Flusher manufacturer's instructions to purge the transmission fluid cooler tubes and the transmission fluid cooler prior to starting the flushing procedure.
9. Allow the Transmission Cooling System Heated Flusher to backflush for 10-15 minutes, then flush the transmission fluid cooler in a normal flow direction for an additional 10-15 minutes.
10. If the transmission fluid cooling system heated flusher is equipped with an inspection micron filter:
Original technical text and illustrations, formatted as HTML. Follow the engine, transmission, equipment, model and year specified in the source. Import and layout checks do not establish applicability to every 2015–2017 Mustang. About this collection.