MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Frame and Mounting

Rear Subframe

502-00 Uni-Body, Subframe and Mounting System

2016 MustangReference 2,395 / 6,619HTML edition
← Chapter contentsProcedure contents
Rear Subframe — original illustration 1, reference 2395Original colors & callouts · Select to enlarge

13. NOTE: If equipped with dynamic suspension.

Install both rear ride height sensors. Refer to: Rear Suspension Height Sensor (204-05 Vehicle Dynamic Suspension, Removal and Installation).

14. Install the rear stabilizer bar. Refer to: Rear Stabilizer Bar (204-02 Rear Suspension, Removal and Installation).

15. Install both rear springs. Refer to: Spring (204-02 Rear Suspension, Removal and Installation).

16. Install both toe links. Refer to: Toe Link (204-02 Rear Suspension, Removal and Installation).

17. Install both rear halfshafts. Refer to: Rear Halfshaft (205-05 Rear Drive Halfshafts, Removal and Installation).

18. Check the differential fluid level. Refer to: Differential Fluid Level Check (205-02 Rear Drive Axle/Differential, General Procedures).

Copyright © 2016 Ford Motor Company

Source reference 2395

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.