Oil Pan
Base Part Number: 6675
Special Tool(s) / General Equipment
303-050 (T70P-6000) Lifting Bracket, Engine | |
303-F072 Support Bar, Engine | |
Plastic Scraper | |
Oil Drain Equipment | |
Vehicle/Axle Stands | |
Materials
Name | Specification |
|---|---|
Motorcraft® Silicone Gasket Remover ZC-30-A | - |
Engine Oil - 5W20 | WSS-M2C948-B |
Motorcraft® Metal Surface Prep ZC-31-B | - |
Silicone Gasket and Sealant TA-30 | WSE-M4G323-A4 |
Metal Brake Parts Cleaner (U.S.) PM-4-A, PM-4-B (U.S.) | - |
Removal
6-Speed Automatic Transmission - 6R80/6-Speed Manual Transmission - MT82
NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
2. Disconnect the battery ground and positive cables. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
3. NOTICE: Make sure to minimize damage to sealer foam and avoid pulling apart dash seal brackets
from retainer pins. Excessive damage may allow engine noise, fumes, air or water to enter the passenger compartment.
1. Remove the steering column dash seal nuts.
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.