Tie Rod
Special Tool(s) / General Equipment
204-816 Rack Holding Tool TKIT-2014D-FL_ROW TKIT-2014D-ROW2 | |
Boot Clamp Pliers | |
Materials
Name | Specification |
|---|---|
Premium Long-Life Grease XG-1-E1 | ESA-M1C75-B |
Removal
NOTICE: When servicing inner tie rods, install a new bellows boot and clamps. The boots and clamps are designed to provide an airtight seal and protect the internal components of the steering gear. If the seal is not airtight, the vacuum generated during turning will draw water and contamination into the gear, causing failure of the steering gear components. Zip ties must not be used as they do not provide an airtight seal.
NOTICE: The inner ball joint grease is not compatible with water contamination. Do not allow water to become trapped in the grease or degradation and failure of the joint may occur.
NOTE: If the RH inner tie rod is being serviced, remove the LH outer tie rod end and bellows boot to access and hold the steering rack when loosening and tightening the inner tie rod.
1. Remove the tie rod end. Refer to: Tie Rod End (211-02 Power Steering, Removal and Installation).
2. NOTE: If equipped.
Remove the bolts and the underbody shield.
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.