Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C175B-1 | Ground | |
C175B-58 | Ground |
Are the resistances greater than 10,000 ohms?
Yes | GO to A22 |
|---|---|
No | REPAIR the affected circuit. |
A22 CHECK THE PCM (POWERTRAIN CONTROL MODULE) STARTER RELAY CIRCUITS FOR AN OPEN
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C175B-1 | BJB starter relay pin 1 | |
C175B-58 | BJB starter relay pin 2 |
Are the resistances less than 3 ohms?
Yes | GO to A28 |
|---|---|
No | REPAIR the affected circuit. |
A23 CHECK THE CPP (CLUTCH PEDAL POSITION) SWITCH OPERATION
Ignition OFF. Disconnect PCM C175B. While fully applying the clutch pedal, measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C175B-9 | Ground |
Is the resistance less than 3 ohms?
Yes | GO to A28 |
|---|---|
No | GO to A24 |
A24 CHECK THE CPP (CLUTCH PEDAL POSITION) GROUND CIRCUIT FOR AN OPEN
Disconnect CPP switch C2353. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C2353-2 | Ground |
Is the resistance less than 3 ohms?
Yes | GO to A25 |
|---|---|
No | REPAIR the circuit. |
A25 CHECK THE CPP (CLUTCH PEDAL POSITION) SWITCH CIRCUIT FOR AN OPEN
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.