B-Pillar and Reinforcement - Convertible
Special Tool(s) / General Equipment
Resistance Spotwelding Equipment
Air Body Saw
8 mm Drill Bit
MIG/MAG Welding Equipment
Spot Weld Drill Bit
Locking Pliers
Materials
Name | Specification |
|---|---|
Seam Sealer TA-2-B | - |
Fusor® Flexible Foam Repair 3M™ 08463, Fusor® 121 | - |
Removal
NOTE: LH side shown, RH side similar.
1. If required, dimensionally restore vehicle to pre-accident condition. Refer to: Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation).
2. Remove the following items:
1. Refer to: Rear Seat Cushion (501-10B Rear Seats, Removal and Installation).
2. Refer to: Quarter Panel - Convertible (501-30 Rear End Sheet Metal Repairs, Removal and Installation).
NOTICE: B-pillar reinforcement components are constructed of Boron steel and can not be sectioned. Replacement must be done at factory joints.
3. Position aside the carpet and wiring harness from the repair area.
4. Remove the bolts from the rear floor crossmember to B-pillar.
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.