Countershaft

308-03A Manual Transmission - 6-Speed Manual Transmission - 2016 Mustang MT82

Procedure revision date:

Disassembly and Assembly of Subassemblies

04/30/2015

Special Tool(s) / General Equipment

308-03A Manual Transmission - 6-Speed Manual Transmission -MT82 — original illustration 1, reference 3098Original colors & callouts · Select to enlarge	205-153 (T80T-4000-W) Handle
308-03A Manual Transmission - 6-Speed Manual Transmission -MT82 — original illustration 2, reference 3098Original colors & callouts · Select to enlarge	308-130 (T87T-7025-DH) Installer, Shift Rail Needle Bearing TKIT-1987-FLMH
Hydraulic Press
Bearing Separator

Materials

Name	Specification
Motorcraft® Dual Clutch Transmission Fluid XT-11-QDC	WSS-M2C200-D2

DISASSEMBLY

NOTICE: Hand-tighten the Bearing Puller to prevent gear damage.

NOTICE: Support the countershaft while using the hydraulic press to prevent damage to the shaft or gears.

NOTICE: Removing the Fifth and Sixth gears may take up to 18,000 pounds of force. Do not heat the gear.

1. Using the special tools, bearing separator and a hydraulic press, remove the 5th gear. Inspect the 5th gear for wear or damage. Install a new gear as necessary. Use Special Service Tool: 308-130 (T87T-7025-DH) Installer, Shift Rail Needle Bearing. , 205-153 (T80T-4000-W) Handle. Use the General Equipment: Bearing Separator Use the General Equipment: Hydraulic Press

Source reference 3098

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.