REMOVAL AND INSTALLATION > FRONT COVER TO COOLANT PIPE SEAL
Special Tool(s) / General Equipment
303-1528 Remover/Installer, Water Tube Seal
REMOVAL AND INSTALLATION > FRONT COVER TO COOLANT PIPE SEAL >
REMOVAL
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, may cause engine failure.
1. Remove the coolant pump. Refer to: COOLANT PUMP .
2. Using the special tool, remove the front cover to coolant pipe seal.
Reset the special tool center bolt to its retracted position.
Use Special Service Tool: 303-1528 Remover/Installer, Water Tube Seal.
Screw the special tool onto the front cover to coolant pipe seal until it bottoms out.
Using a brass hammer, give the special tool a slight tap inward to break front cover radial seal lose.
Turn the special tool center bolt clockwise and remove the front cover to coolant pipe seal.
Original technical text and illustrations, formatted as HTML. Follow the engine, transmission, equipment, model and year specified in the source. Import and layout checks do not establish applicability to every 2015–2017 Mustang. About this collection.